Re: Pre Heating WVO before injector pump
My experience aligns with pretty much all that has been posted. Especially not bothering using any electronic fuel heating system.
I have had the two 20PHEs block up however after many years of use with polymer material.
Been able to clear one of them and reinstalled but can't seem to shift the blockage in the other despite lengthy soaking in ULP and many attempts blowing through with compressed air.
Re the eBay link to the stainless 30PHE (300mm long), would it matter much if this was mounted horizontally once the flow directions had been established?
Laurie
My experience aligns with pretty much all that has been posted. Especially not bothering using any electronic fuel heating system.
I have had the two 20PHEs block up however after many years of use with polymer material.
Been able to clear one of them and reinstalled but can't seem to shift the blockage in the other despite lengthy soaking in ULP and many attempts blowing through with compressed air.
Re the eBay link to the stainless 30PHE (300mm long), would it matter much if this was mounted horizontally once the flow directions had been established?
Laurie
Comment