Results 1 to 2 of 2

Thread: blend advice for oil boiler

  1. #1
    Join Date
    Mar 2014
    Location
    CT, USA
    Posts
    1

    blend advice for oil boiler

    I am trying to get into WCO and I'm looking for some advice for blending WCO to use in my oil fired home heating boiler. I've heard that that I one can add a small amount of kerosene and gasoline to WCO and run directly into a oil fired boiler. It seems that since my basement is a reliantly constant temp I should have less problems with the oil getting too thick when it gets cold out.

    Has anyone had success doing this? does anyone have a recommended setup/recipe they will share?

    THANKS!
    Jared

  2. #2
    Join Date
    Apr 2011
    Location
    Lismore NSW
    Posts
    329

    Re: blend advice for oil boiler

    Hey Mate,

    don't know whether thesis what you're after, but the old youtube is your friend. I looked into this a while ago to heat my oil. Still in the planning stage :-)

    https://www.youtube.com/watch?v=8G6uIDKMS5s

    hope it helps
    1990 Toyota Hilux LN106 with ATG 2 tank system (sold after running 150.000 ks on mainly WVO)
    1993 Toyota 75 Series with 1 HZ engine both 75l factory tanks and a custom 170l under tray tank.
    200.000km 80% on bio 10% on WVO 10% on dino,

    "him who never made a mistake, made no discovery either"


Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •