Hey guys,
So glad to have found this forum! For a few months now I have been making 1-L test batches of biodiesel to see if I can make high quality fuel. I have refined my process and now I'm producing very high conversion biodiesel (no fallout with a 3/27 test). After a few washes with water, the fuel fully separates from the water within 10 minutes without leaving an emulsion layer, and the wash water is very clear. Once I'm finished washing it, I try to do a soap titration, but I can't even get a reading because the indicator is yellow before I even put any HCl in there. To me, this indicates that the soap levels must be very low.
Here's where I have doubts. Whenever I wash the biodiesel with water, I get a thick layer of bubbles between the bio diesel and water. It goes away very quick (under 10 minutes), but just the site of it makes me worry that there's something wrong with it. Also, when I get a small sample of the biodiesel on its own and shake it up, it goes very cloudy. Given that the other quality tests seem to indicate that the biodiesel is very high quality, the only way this makes sense to me is if biodiesel is just foamy by nature. Is this correct?
I feel like I could just be overthinking it and already be producing high quality biodiesel, but I just wanted someones thoughts.
So glad to have found this forum! For a few months now I have been making 1-L test batches of biodiesel to see if I can make high quality fuel. I have refined my process and now I'm producing very high conversion biodiesel (no fallout with a 3/27 test). After a few washes with water, the fuel fully separates from the water within 10 minutes without leaving an emulsion layer, and the wash water is very clear. Once I'm finished washing it, I try to do a soap titration, but I can't even get a reading because the indicator is yellow before I even put any HCl in there. To me, this indicates that the soap levels must be very low.
Here's where I have doubts. Whenever I wash the biodiesel with water, I get a thick layer of bubbles between the bio diesel and water. It goes away very quick (under 10 minutes), but just the site of it makes me worry that there's something wrong with it. Also, when I get a small sample of the biodiesel on its own and shake it up, it goes very cloudy. Given that the other quality tests seem to indicate that the biodiesel is very high quality, the only way this makes sense to me is if biodiesel is just foamy by nature. Is this correct?
I feel like I could just be overthinking it and already be producing high quality biodiesel, but I just wanted someones thoughts.

