Search:

Type: Posts; User: tillyfromparadise; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 1.23 seconds; generated 38 minute(s) ago.

  1. Replies
    4
    Views
    444

    Re: 1hz pump rebuilt costs

    Hi 3DB,

    Unfortunately that is not the case. Some Original Equipment Manufacturers have switched to viton hoses and seals while others still use Rubber (Nitrile).
    There was a good discussion on...
  2. Replies
    4
    Views
    348

    Re: Using the tote?

    Hi Pavetim,
    Welcome to the forum.

    Another concern I have is that considering there are corners in a tote, is to insure thorough mixing.
  3. Replies
    7
    Views
    865

    Re: Indonesia goes to B50 next year

    Hi Chev28,

    The current emission standard for new diesel vehicles in Indonesia is Euro 2. This will increase to Euro 4 in 2021.
    As of 1 Jan 2017, diesel fuel is limited to 2500 ppm sulfur...
  4. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    Hi Cade,

    Yes, there is not a huge increase in yield
    This is what Neutral posted about the testing he performed with it.
    Around a 3% increase with WVO containing about 5% FFA.

    "My own...
  5. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    Hi Dgs,


    No.
  6. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    Hi Cade,
    Yes, the 5% pre-wash is certainly counter intuitive, but it does work- I have done it before when I was water-washing my biodiesel.

    The amount of yield gain will depend on the titration...
  7. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    Hi Cade,

    Instead of turning off the mixer and allowing the glycerine to settle for 45 minutes at the end of the reaction, I would immediately do a 5% pre-wash before the glycerine settles as...
  8. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    Hi Cade,


    Bright and clear is sufficient for my situation.
    The quickest way to determine whether you are satisfied with your wash is to do a couple of mini-washes using the World Famous Dr...
  9. Replies
    5
    Views
    684

    Re: weird fault fixed peugeot 406

    Apparently a faulty radio in the newer Chevrolet can cause the engine to not start.
  10. Re: Can you make bio with Frytol oil?

    Hi Jack,
    Welcome to the forum.

    Yes, you can make biodiesel from Frytol exactly like you make biodiesel from veg oil.
    As with any oil, the Frytol must remain liquid throughout the reaction.
  11. All Scania Euro 5 trucks can operate on B100

    All Scania Euro 5 trucks can operate on B100 if specified for it at the factory. Those not factory-specified for B100 can be converted at minimal cost, after a short visit to a Scania workshop....
  12. Replies
    15
    Views
    11,485

    Re: Can I reprocess if failed 27/3 test?

    Hi 3DB

    it will cause no concern if you use it in your 300D. I routinely use much lower conversion biodiesel in my Musso with no ill affects.
    I have no experience with the Isuzu Rodeo but I did...
  13. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    Hi Cade,

    Thank you for your vote of confidence, you have made me blush.

    Typically people wash several times before drying.
    If you go back and look at the picture I posted of the biodiesel in...
  14. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    Hi Wesley,

    Just washed biodiesel with lots of water still in suspension looks like "Orange Juice". You do have to agitate to thoroughtly mix the biodiesel and water.


    ...
  15. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    Hi Cade,

    I can not recall that I have ever used an acid to break an emulsion.
    My thoughts are that you should use as little as possible that will do the job you are after.




    {Quick Edit}It...
  16. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    Hi Cade,

    I think you have answered your own question.
    I would just let it sit and see if the emulsion breaks on it's own, then remove water and continue to heat. Otherwise you know vinegar...
  17. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    PS, I just noticed that Neutrals yields followed very closely Neutral's "rule of thumb" that says soap will take about twice it's volume of biodiesel into the waste/ glycerin.
    In neutral's above...
  18. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    Hi Bueff,

    Adding water to the mix at the end of the reaction before draining the glycerin was first suggested by the people at Idaho university. Their initial recommendation was 15% water which...
  19. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    Hi Cade,

    In your situation, instead of heating the biodiesel until it clears and then allowing to cool, just remove the water that settles out when the biodiesel clears and continue heating.
    I...
  20. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    That is strange, I replied a couple hours ago and it disappeared.
    Second attempt.

    A lot of water will have fallen out by the time the biodiesel has cleared during the initial heating..
    At this...
  21. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    Hi cade,

    If you want to heat your biodiesel to "force" dry it, anything up to 100C should be fine.




    You could make, settle, wash and dry in 24 hours if you wanted to. The biggest slow...
  22. Replies
    60
    Views
    5,408

    Re: My first wash. AARGGHH

    Hi Cade,
    "Orange Juice" is a typical look for water washed biodiesel.
    My experience is that, depending on the temperature and the radio station you are listening to, it will take a day or ten for...
  23. Replies
    16
    Views
    1,289

    Re: Timing on Mercedes engine

    Hi Chevy28.
    Yes I see. I did have several websites open yesterday looking for the info.
    All the info I can find today says both the Auto and the Manual do 0- 100 in 16 seconds.

    Neck snapping...
  24. Replies
    16
    Views
    1,289

    Re: Timing on Mercedes engine

    The Musso 2.9TD 0- 100kph with manual transmission is 16.9 seconds and the Automatic is 19.7 seconds
    https://ssang-yong.drive.place/musso/i/group_offroad_5d/258157...
  25. Re: Practicalities of measuring liquids on a larger scale

    Hi Arvin,
    When I was making 20 litre batches of biodiesel I used a 2 litre plastic container with measurements marked on the side.
    Fill it up 10 times to the 2 litre mark and you have 20 litres...
Results 1 to 25 of 498
Page 1 of 20 1 2 3 4