Search:

Type: Posts; User: Alga; Keyword(s):

Page 1 of 20 1 2 3 4

Search: Search took 0.18 seconds.

  1. Replies
    13
    Views
    357

    Re: Need a little tank for my buzzbox

    Tony, I live in Tas, we have no inspections and the local cop has seen my setup and was very impressed.
  2. Replies
    13
    Views
    357

    Re: Need a little tank for my buzzbox

    Tony, been using under bonnet starter/flush tanks for as long as have used VO on cars, never had a problem and would never site them near exhaust or turbo. With the 20lt metal drums, you take the tap...
  3. Replies
    13
    Views
    357

    Re: Need a little tank for my buzzbox

    Most metal 20lt veggie oil drums have taps in them or the facility to put one in, you'll find normal poly pipe fittings fit the thread. You can also get those blue 25lt cleaning fluid plastic drums...
  4. Thread: series 60 brakes.

    by Alga
    Replies
    4
    Views
    384

    Re: series 60 brakes.

    Thanks the front brakes are fine, so will have to go through the system to find the problem. Think the problem may be the master cylinder, which will check today.
  5. Thread: series 60 brakes.

    by Alga
    Replies
    4
    Views
    384

    series 60 brakes.

    When got my series 80, gave my series 60 12ht sahara to my neighbour to use as her car had carked it. Last week she told me her brakes seemed funny, when checked found the left hand rear brake...
  6. Replies
    3
    Views
    506

    Re: Coolant sensor location 1HDT

    Jens, you may find after a while you will have fuel blockages from the main tank, you can't fix them by draining the tank as there is a box type thing in the fuel tank which the pickup sits in, it's...
  7. Replies
    3
    Views
    506

    Re: Coolant sensor location 1HDT

    G'day Jens, you'll find it on the right side of the oil filter, just under the manifold. Can be hard to see as the fuel lines are above it. You'll have to take the oil filter out to get to it, same...
  8. Thread: washing with heat

    by Alga
    Replies
    48
    Views
    7,481

    Re: washing with heat

    G'day Cade, this may not be relevant in this case, but may add some light to what's happening. Have only ever heated BD when drying on the sun, but have heated VO to almost boiling temp to see what...
  9. Re: looking at converting my 2002 Landcruiser with 1HZ engine to WVO

    Series 80 cruisers, have a 10mm fuel line and in my experience, it's adequate to run vo with a push pump installed at the firewall

    Perolin, take out the filter on the fuel line pickup in the main...
  10. Re: looking at converting my 2002 Landcruiser with 1HZ engine to WVO

    G'day Paul, I run a 1hdt series 80 cruiser on VO, as long as you have it set up right it works well. I don't use a kit, made it up myself and you need to have the following for it to work in my...
  11. Replies
    22
    Views
    3,945

    Re: Musso Fuel Gauge stuck at 3/4 tank

    Tony, have the same fuel gauge problem in all my vehicles running on VO. Tried everything, replaced senders and cleaned them up, but over time they go back to acting weird and can go from full to...
  12. Replies
    64
    Views
    10,807

    Re: Problems with 1HDT on SVO

    Have no idea whether it cleans the system or just the chambers, but from my perspective it makes a difference. Have tried it with and without a HE, found it seems to work better when the engine is at...
  13. Replies
    64
    Views
    10,807

    Re: Problems with 1HDT on SVO

    As a chemist, surely you would know the attributes of ATF and how it operates in an engine. As with non synthetic 2 stroke, they have cleansing agents in them and those contribute greatly to cleaning...
  14. Replies
    64
    Views
    10,807

    Re: Problems with 1HDT on SVO

    My 1hdt has been running excellently, early this week got back from a round trip to Nth NSW and it performed flawlessly over the 4000+klms. Don't care what anyone says, with these engines you need...
  15. Replies
    24
    Views
    5,716

    Re: Blending Diesel with Filtered Vegetable Oil?

    Tony, I have a 671gm common rail, it runs much smoother and quieter in vo. Agree the fuel mostly comes into contact with the fuel system, but as on all engines, there is a certain time in the...
  16. Replies
    24
    Views
    5,716

    Re: Blending Diesel with Filtered Vegetable Oil?

    You're right Smithy, adding BD or vo increases the lubricity and makes engines run smoother. There have been many studies which support this, ultra low sulphur diesel, doesn't have the lubricity to...
  17. Replies
    10
    Views
    2,964

    Re: Cooking oil cruiser thanks for

    G'day Mark, I agree there are many different ways others have plumbed for vo. My experimentation was over a decade ago for vehicles and my first use of VO in engines was back in the late 1970's, so...
  18. Replies
    10
    Views
    2,964

    Re: Cooking oil cruiser thanks for

    Interesting video, certainly not the way I have or would set up a 1hdt, to complicated and failure prone. Just settling your oil is also dangerous in my opinion. Have found the difference between...
  19. Replies
    5
    Views
    2,065

    Re: 1HD-FTE and bio performance fix

    Also found filters vary with brand, finally got my 1hdt going well. Had trouble with the large amount of fuel they circulate, so changed the system so all fuel goes through the HE and now there is no...
  20. Replies
    7
    Views
    1,894

    Re: Members willing to share oil with travelling members

    Same as limoman, collect oil along the road and filter it as you go. You can either get filter bags, use those supermarket green or blue re-usable bags, or if you have a trailer, carry a centrifuge....
  21. Replies
    8
    Views
    1,819

    Re: Filter blocking in less than 100k

    Not really a drama, just a learning experience.

    Thanks Tony, didn't notice that stuff up. Looped fuel returns work so much better with VO, especially if you have an engine that has a big fuel flow...
  22. Replies
    8
    Views
    1,819

    Re: Filter blocking in less than 100k

    Had a bit of a problem like this years ago, when using petrol as a blend, but don't think it was the petrol blend or whether it contributed to the problem. Never had a problem since switching to dino...
  23. Replies
    21
    Views
    4,383

    Re: How do I plumb in a heat exchanger?

    Mark, had the same problem as you with the main filter. Now can flush the lines in a minute and having looped the return line and added ball valves, can control where fuel comes from and goes. So...
  24. Replies
    33
    Views
    5,776

    Re: terrano dying after a few k's

    All my vehicles have the push pump near the tank, except for the new series 80 cruiser. There is nowhere to put it with the dual tank setup, so like Artrix, have put it at the firewall and you can...
  25. Re: Glycerol / glycerine / biodiesel byproduct as rust inhibitor?

    Straight veggie oil may be better for a rust inhibitor, BD is a great cleaner and takes oil out of concrete quite well. On my boat where veggie has spilled, leaked or whatever on metal there is no...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4